Reply
Member
Posts: 1
Registered: ‎16-06-2021
0

E1 Cable Connection to a BT ASDH NTE 4U/7A providing Q.931 Service

Hello all,

 

 

I am struggling to connect my gateway to a BT ASDH NTE 4U/7A. This is providing a Q.931 ISDN service.

 

My gateway installation manual says I need to make a 120 ohm crossover cable using Cat5 and RJ45/RJ48 connector by termianating as follows:

Pin 1---Pin 4
Pin 2---Pin 5
Pin 4---Pin 1
Pin 5---Pin 2

 

So I made the cable up and there isn't a Layer 1 link (customer LED is amber and not off). I have tried a straight through cable, still nothing

 

I have another E1 link to a different BT ISDN unit (NTE 2D) and this connects fine to my other gateway which is exactly the same as my first gateway with exactly the same config but via a straight through patch cord.

 

Can anyone advise if I need to use a special cable or a special pin out to interface to a BT ASDH NTE 4U/7A, or if there is an instalaltion manual/datasheet for it please?

 

Thanks in advance!

Administrator
Posts: 96
Registered: October
0

Re: E1 Cable Connection to a BT ASDH NTE 4U/7A providing Q.931 Service

Hi skyblue1991

 

Apologies for the late reply - did you manage to get this one sorted? If not, please privately message me so I can take some details and have a look. Hopefully all is well now.

 

Beth

/* /